Does drip edge go over or under underlayment?

According to most building codes and manufacturer recommendations, the drip edge should be installed beneath the underlayment along the eaves of the roof. But over the underlayment along the rake edges of the roof. Understanding the proper way to install the drip edge will only get you so far.Click to see full answer. Similarly, does tar paper go over or under drip edge?The drip edge should be over the paper at the eaves, and under along the rake. mroberson: Its a TRAP! Back in my construction days, I learned that you place the tar paper OVER the drip edge on the eaves so if moisture gets through the shingles, it does not get under the drip edge.Likewise, does fascia go under drip edge? The correct placement of a roof drip edge is on top of the roof’s exterior cover directly between the sheathing and the fascia board, which forms a drainage gap between the drip edge and the fascia board. As a result, the drainage improves water flow and protects the roof from potential water damage. Similarly, does drip edge go over or under felt? 1 Answer. It depends on where the drip edge is. At the side, or gabels, of a roof, the drip edge goes over the roofing felt. At the bottom of the roof, the drip edge goes under the roofing felt.How far should shingles overhang the drip edge?The edge of the shingles should hang over a roof between an inch and an inch and a half — or between a half inch and three-quarters of an inch if drip edge flashing is installed. Too much overhang and the shingles could blow off in high winds; too little can allow water to seep into rake or fascia boards.

ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6dpp6rXZm%2FqryMnpugnV2cvG671Z6pZqeiYsKvsMSrZK6mlJq%2Fra3YppynrF1nfA%3D%3D